Tuesday, October 1, 2013

this guy is my friggin' hero

don't mess with Kyle Deneen. skinned a snake after it bit him. a diamondback. THEN went to the hospital.
he's a bad ass!
don't bite me, asshole!

1 comment:

  1. Some fashions are so advanced that the generated supports are very hard to clean. It would take some experience and plenty of patience for somebody to clean these prints. After 3d printing, the resulting print must be cured, cleaned and polished earlier than have the ability to|you probably can} contemplate them useable. That is that if the 3d printing service company cares in regards to the quality of their product. Even if Craft Scissors With Covers you're new to 3d printing, might have} most likely heard of "ABS" or "PLA".

    ReplyDelete